China Best Magnetic Contactor Suppliers – SC(B)H15 Series Amorphous Alloy Dry Type Transformer – Changan Group

Product introduction

SC (B) H15 series amorphous alloy dry-type transformer produced by the company is a kind of dry-type transformer with low loss
and high energy efficiency. The product has the advantages of small local discharge, low loss, good heat dissipation performance,
good moisture-proof ability, strong anti-sudden short circuit ability, large overload capacity and beautiful appearance. Its no-load
loss is more than 70% lower than that of the traditional transformer with silicon steel core. It is a new generation of energy-saving,
safe, green and environment-friendly high-tech product.
The product can replace the ordinary dry-type transformer and is mainly used in high-rise buildings, commercial centers,
subways, airports, stations, industrial and mining enterprises, power plants and other electric fields.

Model Meaning

Standards

GB/T 1094.1-2013 Power transformers – Part 1: General
GB/T 1094.11-2007 Power transformers – Part 11: Dry-type transformers
GB/T 10228-2015 Specification and technical requirements for dry-type power transformers
IEC60076-1:2011 Power transformers – Part 1: General
IEC60076-11:2018 Power transformers – Part 11: Dry-type transformers

Normal Environment conditions

1.Ambient Temperature: No more than +40℃
No less than -25℃
The monthly average temperature is no more than +30℃
The yearly average temperature is no more than +20℃
2.Altitude: No more than 1000m.
3.The power supply voltage’s wave is similar to sine wave.
4.Three-phase power supply voltage is approximately symmetrical.
5.The relative humidity of the surrounding air should be less than 93%. There should be no water droplets on the coil surface.
6.Installation Site: Indoor or outdoor.

Product characteristics

1. The iron core is made of amorphous alloy material and adopts three-phase three column structure. The iron core is suspended on
the reinforced insulation board on the upper part of the coil, which is completely free from the influence of external force. It gives
full play to the characteristics of amorphous alloy material with low no-load loss and low no-load current, and has obvious energysaving effect.
2. Rectangular winding is used for high and low voltage, and the inner and outer layers are filled and wound with glass wire mesh and
glass ribbon, which is integrated with resin penetration curing, and has strong anti-cracking and anti-sudden short circuit ability.
3. The transformer adopts the frame type clamp structure, and the coil is compressed by the elastic pressure nail, so the overall
structure is simple and beautiful.
4. Advanced technologies such as vacuum film degassing, metering pump and static mixing are adopted to ensure the proportioning
accuracy and pouring quality of epoxy mixture. The partial discharge of winding is less than 5pc.
5. HTC winding adopts advanced “air passage rod” technology, which is not limited by the curvature radius of the winding group.
According to the design requirements, one or more layers of axial air passage are set in the heating center of the winding, so as to
achieve the best heat dissipation effect of the whole machine. At the same time, a plurality of support bars can be generated in the
air passage, which effectively enhances the mechanical strength of the winding.

SC(B)H15 Technical Parameter

Dimensions